purlJam

# Wiggly Waves Scarf
*A gently undulating scarf with continuous S-curves*

Inspired by Helena Wieser's innovative design, this beginner-friendly scarf features a mesmerizing wave pattern created through simple increases and decreases. The fabric flows in an S-shape while maintaining a consistent width, creating visual interest and a beautiful drape.

## FINISHED MEASUREMENTS
- Width: Approximately 6" (15 cm) at widest point, 5" (12.5 cm) at narrowest point (due to bias created by shaping)
- Length: Approximately 60" (152 cm), easily adjustable

## MATERIALS
**Yarn**: Worsted weight yarn, approximately 400 yards (366 m)
- Sample shown uses approximately 2 skeins of worsted weight yarn with approximately 200 yards per skein

**Needles**: US 8 (5 mm) straight or circular needles, or size needed to obtain gauge

**Notions**: 
- Tapestry needle for weaving in ends
- Stitch marker (optional, for marking right side)

## GAUGE
20 stitches and 40 rows = 4" (10 cm) in garter stitch (knit every row), after blocking

*Gauge is not critical for this project, but will affect yardage and finished size.*

## ABBREVIATIONS
- k: knit
- kfb: knit into front and back of same stitch (1 stitch increased)
- k2tog: knit 2 stitches together (1 stitch decreased)
- RS: right side
- WS: wrong side
- st(s): stitch(es)

## PATTERN NOTES
- The scarf is worked flat in garter stitch (knit every row).
- The wave pattern is created by decreasing at one edge while simultaneously increasing at the opposite edge, keeping the total stitch count constant at 30 stitches.
- Every 20 rows, the decrease and increase edges switch, creating the S-curve wave pattern.
- Mark the right side with a removable marker if desired, though both sides look identical in garter stitch.
- The scarf will have a slight bias due to the shaping, which is normal and adds to the flowing effect.

## INSTRUCTIONS

**Cast On**
Cast on 30 sts using your preferred method.

**Setup Rows**
Rows 1-4: Knit across. (This creates a small straight section at the beginning)

**Wave Pattern - Section A (Right-leaning wave)**
Row 1 (RS): K2tog, knit to last st, kfb. (30 sts)
Row 2 (WS): K2tog, knit to last st, kfb. (30 sts)

Repeat Rows 1-2 nine more times (20 rows total).

*Math check: Starting sts: 30. Each row: -1 + 1 = 30 sts maintained.*

**Wave Pattern - Section B (Left-leaning wave)**
Row 1 (RS): Kfb, knit to last 2 sts, k2tog. (30 sts)
Row 2 (WS): Kfb, knit to last 2 sts, k2tog. (30 sts)

Repeat Rows 1-2 nine more times (20 rows total).

*Math check: Starting sts: 30. Each row: +1 - 1 = 30 sts maintained.*

**Complete S-Curve**: One complete S-curve = Section A + Section B = 40 rows total.

**Continue Pattern**
Repeat Wave Pattern Sections A and B alternately until scarf measures approximately 60" (152 cm) from cast-on edge, or until scarf is 4" (10 cm) shorter than desired finished length, ending after completing either a full Section A or Section B.

*Yardage note: Approximately 15 complete S-curves uses about 375-400 yards.*

**Ending Rows**
Knit 4 rows even (without any increases or decreases).

**Bind Off**
Bind off all stitches loosely. Cut yarn, leaving a 6" (15 cm) tail.

## FINISHING
1. Weave in all ends securely using tapestry needle.
2. Block scarf gently to even out the waves and enhance drape. Wet block or steam block according to yarn label instructions.
3. Lay scarf flat in a gentle S-curve pattern while blocking to emphasize the wave design.
4. Allow to dry completely before wearing.

## PATTERN VARIATIONS

**Wider Scarf**: Cast on 40 stitches instead of 30 for an approximately 8" wide scarf. This will require approximately 550-600 yards of yarn.

**Narrower Scarf**: Cast on 25 stitches instead of 30 for an approximately 5" wide scarf. This will require approximately 325-350 yards of yarn.

**Longer Waves**: Work each section (A and B) for 30 rows instead of 20 rows for more gentle, elongated curves.

**Shorter Waves**: Work each section (A and B) for 12-14 rows instead of 20 rows for tighter, more dramatic waves.

## TIPS FOR SUCCESS
- Count your stitches every few rows to ensure you're maintaining 30 stitches.
- Place a marker on the right side if you find it helpful, though garter stitch looks the same on both sides.
- The edges will appear to "walk" or shift to the right, then to the left - this is correct and creates the wave!
- Don't worry if the scarf looks slightly twisted on the needles; it will relax and show the wave pattern beautifully when blocked.
- Keep your increases and decreases fairly loose to maintain an even edge.

---

*Pattern designed for beginner knitters comfortable with basic increases and decreases. Enjoy your wiggly waves!*